MAXI JOLLY DALI H 65

MAXI JOLLY DALI H 65 - Dimmable constant current LED driver with DIP-SWITCH

Multi-current or multi-voltage LED converter dimmable - universal use in indoor areas. This driver is ideally protected against overheating, overcharging and current peaks and can therefore be used for lighting equipment of protection class 1.

Other features:

Multipower driver with DIP switch to select the output current.

• Indoor IP-20 independent driver (DC MAXI JOLLY DALI H / 2
• Class 1 protection against electric shock for direct or indirect contact (DC MAXI JOLLY DALI H / 2)
• Built-in driver (DC MAXI JOLLY DALI HBI)
• It can be used for protection class 1 lighting devices.
• Active Power Factor Corrector
• Analog input (NTC) for connecting a heat sensor
• Auxiliary output 12 V max. 100 mA
• Current regulation + - 5% including temperature fluctuations
• Input and output terminal blocks on the same side
• Clamping screws on the primary and secondary circuit
• Thermal protection = C.5.a

Operation Mode for 127054 / 127074

• Light regulation 0/0,5 - 100 % by means of PUSH function, 0/1...10 V interface (I = 1 mA) or 100 Kohm potentiometer and DALI.
  • Features DALI dimming:
    - memory function for sets or light groups
    - recall of stored functions;
    - compatible with standard DALI interfaces.
• Light regulation 0/0,5 - 100 % by means of PUSH function (mains voltage):
  
  - a short push to turn on and off;
  - a longer push to increase or decrease light intensity;
  - regulation automatically stops at minimum and maximum values;
  - for another on, regulation or off command, release the push button and give the desired command again.
•  Possibility to use PUSH function to 4/5 drivers without sync cable.
• Maximum length of the cable, from push button to last driver, must be max. 15 m / 49 ft. In case of applications where the cable is longer than 15 m / 49 ft, keep this separate from the 110 - 240 Volt mains cable.
• ATTENTION: only use normally open push buttons with no incorporated warning light.
• Specific dimming terminal connection with a 0/1...10 Vdc electronic potentiometer (0/1...10 V local dimming, double insulation required for external connection).
• Max. 10 synchronised drivers of which only one can be controlled (1 Master + 9 Slaves).
• Synchronization cable is separately supplied. For additional details for regulations see pages info12-14.

For more information see in our Download Tab.